1. Need to set up master code {administrator password} before pairing can be done, (page. 7, 3.2 Long press)
2., In ready mode, press "22 √" on the keypad and enter your master code {administrator password}
(note : A. many customer have not setup master code before APP pairing. B. BT SSID will NOT be seen in normal mobile BT scan. "Homki-01" can only searchable through tuya APP for safety reason.)

Yes. Keypoint : a. need to setup admin password first. B. press "22√"-admin password - use tuya to search
https://www.youtube.com/watch?v=smm1LTed7IM
https://ihomki.com/pages/installation

Very often, the customer forget to setup master code {administrator password) after first time lock installation
Video : provde later

1.Turn on your app, and click "Settings"
2.Find "Auto Lock Delay" and choose time

1. First time setup: Long press "√" to enter your administrator password and confirm with "√"
2. Page 10, section 5.2 : press "11√" - enter current password - enter new Re-enter (to confirm) your administrator password - "√"
3. Press factory reset at under the battery apartment with the long ring needle provided. There will have 4-bi sound stating the lock is being factory reset. Then enter the master code (administrator password) - Long press "√".
Video : https://youtube.com/shorts/8JtwCUEDaRk

Homki-01 :- BT SSID will NOT be seen in normal mobile BT scan. "Homki-01" can only searchable through tuya APP for safety reason.)

Case 1 : if the blue ring cannot light up, change the battery or check front to rear case cable.
Case 2 : if the blue ring lights up and cannot operation. Likely forget to setup master code {administrator password}
Case 3 : press factory reset at under the battery apartment with the long ring needle provided. There will have sound stating the lock is being factory reset. Then enter the master code (administrator password).

There may have two reasons:
8.1. door is thin compare with average. ≤1.65inch（42mm ). Need to cut the lock length

YouTube video : https://youtu.be/wHrI23-ctz4

8.2. The dead bolt motion is reversed due to left - right - door (factory default is right swing)
There are two ways to setup left - right - door swing
8.2.1. use keypad : press "44√" - enter admin password. This will toggle to left swing. Operate again will toggle to right swing.
8.2.2. after APP pairing. Can use APP to setup.

YouTube video：
https://youtu.be/b2qz8nxZprA
https://youtube.com/shorts/PVyN9cmODiw

Press "22√"-admin password - use tuya APP to search

Fit 1.38" to 2" (35mm to 51mm)
' Note : thin compare with average. ≤1.65inch（42mm ). Need to cut the lock length see [8.1]